The AV setup touches on

The following channels are currently in use:

• Ch. 3-4: TG:HACK Dante
• Ch. 9-10: Hack-Radio project pi
• Ch. 13-14: TV
• Ch. 15-16: Chromecast

We have a borrowed set of professional audio Dante receivers that are hooked up in the audio rack. These are owned by skandix from TG:HACK and labelled as such.

These are occasionally used during parties, or when we're borrowing the matelight for use in e.g. Flerbruksen.

Hackeriet does not own any source devices. You are free to map sources onto these from the Dante control software, however the receivers themselves MUST be left untouched in the rack.

The same goes for the audio channels: Do NOT adjust the gain (should be NO GAIN) nor the EQ.

For more details on Dante, see dante.

====

The PC in the audio rack is hooked up to aux out 1+2 on the mixer. Specific audio channels can be forwarded raw to LedFX as desired, without affecting the master output.

This lets us e.g. receive audio from Flerbruksen and analyze it on our end, without (or with) playing the audio on our speakers

1. Turn the aux send knobs to max for the channels that should be sent
   1. For stereo channel pairs: Send the left-panned channel to Aux1, and the right-panned channel to Aux2.
   2. For combined stereo channels: Send to both Aux1 and Aux2. The mixer fixes levels for us.
2. Ensure the aux return is set to infinity for all knobs
3. Ensure return to aux1 (between level & return knobs) is de-pressed
4. Align the levels so that we do not redline the audio card in the mix rack (ring around the gain knobs on the Focusrite, see image below)
   1. The level knobs on the mixer should be used if possible
   2. If those are maxed out, adjust the gain knobs on the audio card