Differences

This shows you the differences between two versions of the page.

--- infra:vending-machine [2025/06/15 14:57] – created 404d
+++ infra:vending-machine [2025/06/21 16:18] (current) – [Empty the condensate drip tank] 404d
@@ Line 1: / Line 1: @@
+<WRAP center round info 60%>
 Hackeriet has a vending machine stocked with various Club Mate flavours, at a cost of 35 kr. You pay through the "Hackercoin" virtual currency, re-stocked through Hula.
+</WRAP>
-====== Regular Maintenance ======
+<WRAP center round important 60%>
+Is the vending machine beeping? See [[#empty_the_condensate_drip_tank|Empty the condensate drip tank]]
+</WRAP>
-===== Re-stocking =====
+====== Guide ======
+===== Dispensing =====
 TODO
+===== Adding credit =====
+You can stock your access card with Hackercoin through [[https://hackeriet.no/hula/coin/|Hula]].
+For more help with Hula, see [[infra:hula|infra:hula]].
+===== Guest card =====
+TODO
+====== Regular Maintenance ======
+===== Re-stocking =====
+TODO
 ===== Empty the condensate drip tank =====
 The cooling loop in the vending machine generates water condensate that gets collected in the bottom left of the vending machine.
-This needs to be emptied regularly in order to avoid water spills, running out over and ruining the floor paneling.
+This needs to be emptied regularly in order to avoid water spills, which run out of the machine and collects on the floor, ruining the floor paneling.
   - First unlock the machine by twisting the key.
   - Twist the handle for the door until you can pull the door towards you.
   - Reach for the container behind the cables at the bottom of the machine.
-  - Once you have a hold of the container, empty it in the sink.
+  - Once you have a hold of the container, unthread the sensor, shake any residual water out of it, and empty the container into the sink.
-  - After emptying the container place it back where you retrived it from, making sure to position the container directly under the hole so that the water drips into the container again.
+  - After emptying the container thread the sensor back in, place it back where you retrieved it from, making sure to position the container directly under the hole so that the water drips into the container again.