Differences

This shows you the differences between two versions of the page.

--- infra:hosts:chucktheplant [2026/07/21 17:40] – Update chucktheplant known facts atluxity_idp.hackeriet.no
+++ infra:hosts:chucktheplant [2026/07/21 17:50] (current) – Document disconnected TellStick status atluxity_idp.hackeriet.no
@@ Line 2: / Line 2: @@
 Raspberry Pi labelled ''chucktheplant.hackeriet.no''.
+Current status, as of 2026-07-21:
+  * The TellStick has been disconnected to avoid disturbing another tenant in the building.
+  * Nexa plug control from this host should be considered disabled while the TellStick is disconnected.
+  * The Raspberry Pi itself may still be powered and running.
 Current understanding, as of 2026-07-21:
   * The host is a physical Raspberry Pi at Hackeriet.
-  * It has a blue USB TellStick attached.
+  * It has a blue USB TellStick attached, currently disconnected.
-  * The TellStick controls at least one Nexa power plug.
+  * The TellStick controls at least one Nexa power plug when connected.
   * The useful thing to change for the Nexa plug is the TellStick/Nexa channel or learned code, not the RF carrier frequency.
   * The hostname ''chucktheplant.hackeriet.no'' is not currently present in DNS.
@@ Line 42: / Line 48: @@
 ===== TellStick / Nexa notes =====
+The TellStick is currently disconnected. This was done on 2026-07-21 to avoid disturbing another tenant in the building.
 For TellStick plus self-learning Nexa plugs, the relevant configuration is usually in ''/etc/tellstick.conf'' using the ''arctech'' protocol. The channel/code-like values are normally ''house'' and ''unit'' parameters. Changing those requires re-learning the receiver.